Compact IO Module DI-16-C
£135.85 Exc. VAT
The 16-channel digital input module is used to read and detect digital signals for indication, alarm, or impulse measurement purposes.
Digital open collector output module, 16 inputs, max 100mA/channel.
- Screwless installation with click-on DIN-rail communication bus and power connectors
- Push-in spring connectors for cables
- Individually detachable terminal blocks per channel
The 16-channel digital input module is used to read and detect digital signals for indication, alarm, or impulse measurement purposes. Each channel can be individually configured, and has a green and red LED to show its current status. Connect the module to a serial Modbus master controller to get reliable and fast indications from your field equipment.
Below you will find a presentation of the Fidelix FdxCompact DI-16-C 16-Channel Digital Input module. How to connect, configure, use, communicate with, and interpret values and signals from the module.
T Bus connecter (Terminal C) required for MODBUS + and - connection along with other supply voltage 24VDC and consumes 15mA.
If more than 1 module is being installed, you only need one terminal connector, if connecting say 10 of the same or different modules, only one T Bus connector is required.
Communication: Modbus RTU (RS485) at speeds up to 57600 bps. Use no parity, 8 data bits and 1 stop bit. The module will auto-detect the communication speed of the bus (9600, 19200, 38400 or 57600 bps).
Modbus address: The address of the module can be set from 1 to 63 by changing the position of dip-switches 1-6. Each dip-switch represents a binary value, as indicated on the module and datasheet.
Modbus loop termination: On the last module, the Modbus loop must be closed by connecting a 120 Ω resistor between the A and the B side of the RS-485 loop.
DI-16-C Fidelix Digital input module
– 16 digital inputs
– Indication, alarm, and heart rate recording
– Galvanically isolated channels
– Multicolored LED indications
– Pluggable connection terminals
– RS-485 communication with Modbus protocol
– Mounting on DIN rail
The DI-16-C is used to read digital signals for indications, alarms or heart rate measurements.
Each channel can be configured individually and has a green and a red LED to show the current status.
Quick and easy installation as the power supply and communication are integrated into the DIN rail.
Watch The YouTube video: DI-16-C youtube
Supply voltage: 24 VDC (+/- 10%)
Current consumption: 5 mA + (16×2 mA)
Ambient temperature operation: 0 to +40ºC Ambient humidity operation: Max 95%RH, non-condensing
Module size: 134 mm x 78 mm x 19 mm
Module weight: 90 g
Protection class: IP20
Communication speed: 9600 bps, 19200 bps, 38400 bps or 57600 bps
Address range: 1 – 63
Communication protocol: Modbus RTU
Supply scan voltage DI: 20 – 24 VDC
Scan current: 2 mA at 24 VDC / closed circuit
Allowed resistance open contact: 50 kΩ – ∞ (parallel) at 24 VDC scan voltage
Permitted minimum pulse length: Programmable, 5 ms – 1275 ms
|Dimensions||13.4 × 1.9 × 7.8 cm|